[. . . ] Operating Instructions Mode d’emploi Bedienungsanleitung Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory drawings. [. . . ] Refer to Specifications on page 27 for the range of sound that can be adjusted by each control.  Switching the function of the [EQ/ISO (HI, MID, LOW)] controls Switch the [EQ CURVE (ISOLATOR, EQ)] selector switch.  Start playback using the channel fader 1 Set the [CROSS FADER ASSIGN (A, THRU, B)] selector switch to [THRU]. Monitoring sound with headphones 1 Connect headphones to the [PHONES] terminal. € [MONO SPLIT]: The sound of the channels for which the [CUE] button is pressed is output from the headphones output’s left 3 Set the channel fader to the nearest position towards you. If you set the channel fader back to the original position, the player instantaneously returns to the cue point already set and pauses playback (back cue). 14 En  Start playback using the crossfader 1 Set the [CROSS FADER ASSIGN (A, THRU, B)] selector switch to [A] or [B]. To adjust the sound output from the [USB] terminals, select [REC OUT] at [Mixer Audio Output] in the setting utility. The sound’s left/right balance changes according to the direction in which the [BALANCE] control is turned and its position. Rotating to the rightmost position outputs only the right sound of stereo audio. Rotating to the leftmost position outputs only the left sound of stereo audio. Set to the edge opposite the side on which the channel you want to use with the fader start function is set. If you set the crossfader back to the original position, the player instantaneously returns to the cue point already set and pauses playback (back cue). Audio is output from the [BOOTH] terminal Turn the [BOOTH MONITOR] control. Using a microphone 1 Connect a microphone to the [MIC1] or [MIC2] terminal. When set to [TALK OVER], the sound of channels other than the [MIC] channel is attenuated by 18 dB (default) when a sound of -10 dB or greater is input to the microphone. The [TALK OVER] sound attenuation level can be changed at [USER SETUP] screen. For instructions on changing this, see Changing the settings on page 23. For instructions on changing it, see Changing the settings on page 23. Pay attention that rotating to the extreme right position outputs a very loud sound.  Adjusting the sound quality Turn the [MIC] channels’ [EQ (HI, LOW)] controls. Refer to Specifications on page 27 for the range of sound that can be adjusted by each control. [. . . ] Is the external effector’s audio output level set to an appropriate level?Tempo (BPM) cannot be measured or Is the audio input level too high or too low?This unit is not recognized after it has been connected to a computer. Is the [CD/LINE, PHONO, LINE, USB */*] selector switch set to the proper position? [. . . ]